How to Use and Care Your Mink Lashes

How to use your mink lashes

Measure your mink lashes and trim as needed

Firstly, you need to apply a coat of mascara and eyeliner to your natural lash line. Now, carefully remove the lashes from its tray with the help of tweezers or eyelash applicator. Make sure you do not pull or tug on the hair.

Measure these lashes right up to your eye in a way that it properly fits the length of your lash line. Now trim just as much as would make the lashes a little shorter than your natural eye length. Make sure to trim not from the inner corner but from the outer part.

Use lash glue

Hold the lashes right at the head of your tweezers or eyelash applicator and squeeze them gently. Take some glue and apply just a thin layer on to the eyelash band. Allow it to dry for about 30 seconds or until you find the glue getting sticky.

Apply the lashes and hold

Tilt your chin a little up and apply these lashes above the natural lash line. Keep holding for a short while, about a few seconds, so that the glue dries, and then release the lashes from the grip of the applicator. You may have to gently press the lashes on your lash line so that the hair blends well. If you notice any lifting then just add a little more glue and press the lash on to your lash line again. Once the glue dries you can apply your liner once again, and the look is complete.

How to care the mink Lashes

Once you are back home and are about to remove the lashes, do so gently, and then clean them well. Cleaning the lashes carefully extends its durability, and thus must be done with care. So, let us now learn more about the cleaning process.

Be careful and gentle

While removing the mink lashes, be very careful. Remove them gently, as any extra pressure will only damage them. But before you remove them you need to wash your hands with a fragrance-free soap. Now, apply a little makeup remover (water-based) on to the lashes to help loosen the glue. After a few seconds, hold the corner of the mink lash and pull it off gently. Hold the corner and not the hair while pulling.

Get rid of the glue

Once you have the lashes out you need to get rid of the glue from your natural lash line. This is important because if not done properly it may affect your lash line, furthermore, you will find it difficult to reapply the false lashes onto your lash line.

Clean naturally

Getting rid of any glue from the false eyelashes is very important. You can use your tweezers and release any glue both from the front and back sides. If needed, scrape off any remaining glue with the help of your fingernail.

Clean with water

Rinse the lash band using water, but make sure the water does not reach your mink eyelash tips as that may affect the curl and the quality as well. You can use a wet Q-tip to avoid water reaching the lash tips.

Place the lashes on the lash box

Once you have cleaned and the lashes have dried, place them back in their original box. Keep the box well closed to avoid dust or bacteria from settling on to your beautiful lashes.

Now that you know it all, make sure you use your mink lashes carefully and also clean them well always so that they stay in proper shape and last you for a very long time.

Leave a Reply

Your email address will not be published. Required fields are marked *